Bosch F016800345 Replacement 8 m x 1.6 mm Spool Line for ART 35 Heavy Duty Trimmer

Product Information

Drill a hole in the center of the disc that matches the diameter of the gearbox shaft. Do not forget to put a washer on it before installing the disc on the shaft. Next, remove the line spool from the drum shaft. It is mounted on a shaft without fasteners, therefore it can be removed with one hand. After that, you can proceed to dismantling. To do this, you do not need to pull it with all your strength, but slightly shaking it to the sides, slowly disengage it from the metal shaft on which the drum is seated. Electric trimmer and lawn mower users often face a problem with a semi-automatic mowing head. Coil malfunctions can be as follows: Reels for electric and gasoline braids can be with one or two line tendrils. The former are used for trimming low grass growth, the latter for mowing tall grass and small shrubs. We carry out the winding of the fishing line

When assembling the unit, treat the threaded seat with lubricants, for example, grease or machine oil. Periodic removal of the head is recommended to prevent corrosion of the threaded connection. If you never unscrew the screw, then if necessary, it will be difficult and even impossible to do this. Usually, the process of changing the line on a particular model trimmer is popularly described in the accompanying documentation. Another question is that this documentation is often supplied in a foreign language, since the notorious lawn mowers for the most part are imported products.Assemble the mowing head. Be sure to insert the spring and washer (if equipped) before final assembly of the accessory. Place the spool in the body and thread the ends of the cord through the holes or lugs.

This process is not difficult, and as you know, there is no need to dismantle the entire head if you know how the replacement is performed. When dismantling, consider the following nuances: There are times when the user of the grass trimmer notices a very fast line flow. At the same time, he never hit the ground with a button to lengthen the line. The reason that the line spontaneously lengthens, being cut on a special knife on the casing of the device, may be the absence of a spring in the mowing head. Often novice users of mowers, trying to load the line into the reel, forget to install the pressure spring in the head, or completely lose it when opening the lid, and in the future, do not even know about its existence. Trimmer mowing heads come in a variety of designs, both simple and complex. The picture below shows an exploded view of a semi-automatic trimmer head from a Husqvarna (Husqvarna) brushcutter. The main part of the drum is fixed with a screw, which must be unscrewed with a screwdriver with an appropriate tip or bit Turn the tool upside down and, if necessary, clean it from dirt. With two fingers of one hand, grip the cover latches (on the mowing head), which are symmetrically positioned to each other. After lightly pressing them inward, remove the protective cover from the drumCut off the required amount of line. Usually its length is 5 meters. Use a cord of the same diameter as indicated in the instructions for the tool. It is not recommended to exceed the maximum line diameter as this will result in increased engine load and higher gas mileage. So, the mowing head is a cylindrical body in which a bobbin with a fishing line is placed. Such a detail is present both on electric trimmers and on gasoline scythes of any brands, be it Bosch, Makita, STIHL or another brand. There are three types of heads depending on the method of threading and feeding the line. In the first case, third-party cord can be made of low-quality and low-melting materials that cannot withstand mechanical and thermal stress. Therefore, you should give preference to “branded” lines.